Victron Energy Phoenix Inverter 12/3000 Smart

Victron Energy Pheonix 12/3000 Smart Inverter

Features:
Inverters are short-circuit resistant and are protected against overheating caused by overload or high ambient temperature.
Low battery voltage
Low battery voltage disconnect and restart levels
Dynamic disconnection: load-dependent disconnection level
Output voltage: 210 - 245V
Frequency: 50 Hz or 60 Hz
ECO mode on/off and level sensor for ECO mode

VE.Direct communication port
The VE.Direct port can be connected to a computer (VE.Direct to USB interface cable required) to set and monitor the same parameters.

High starting power
Required to switch on consumers such as power converters for LED, halogen lamps or power tools.

ECO mode
When in ECO mode, the inverter will switch to stand-by mode when the load drops below a certain preset value. In stand-by, the inverter will switch on for a short period of time, every 2.5 seconds (adjustable).
If the load exceeds the preset level, the inverter will remain on.

Remote start/stop
A remote switch or relay contact can be connected to a two-pin connector.
Alternatively, the H (left) terminal of the two-pin connector can be switched to the positive pole of the battery or the L (right) terminal of the two-pin connector can be switched to the negative pole of the battery (or the chassis of a vehicle, for example).

LED diagnostics
Please refer to the manual for description.
To transfer the load to another AC source: transfer switch

For our low power inverters we recommend using the Filax transfer switch. Filax has a very short switching time (less than 20 milliseconds), so that computers and other electronic equipment will continue to operate without interruption. Alternatively, use a MultiPlus device with a built-in transfer switch.